| Subject | Text |
| sony 25xid | I dont think its the CRT because sometimes working fine |
| re; too bright | Hi, try turning the "screen control" counter clockwise a little, I
don`t work on monitors so I`m no |
|
|
| vertical IC in your television | The vertical IC is never mounted on the crt board.
In modern TV's, it could be a TO220 device (TDA9 |
| JVC AV-35BP3 Schematic Needed for Charity Work | Need a schematic for a JVC av-35bp3.
This is for a set donated to charity.
Symptoms: DOA, rel |
| Thanks madmatt2024 :idea:
I think you've given good suggestions & precautions, that's very |
| ak19 | [b:d7090ddf95][i:d7090ddf95] :D firstl check the 2,2 ohms fusible for oc,(ew circuit),check c630 for |
| Yes, right, it's likely to be the screen voltage wire. It's either that or a crt board ground. If y |
| Test your CRT for weak emision. If weak the video is blanked out. They can be restored with a sencor |
| Gateway VX1120 or Mitsubishi 2060u Service manual? | Hello
Im looking for the service manual for either of those monitors, I search everywhere and I c |
| hello,
check the crt socket for some corrosion at the focus. if you find some bluish color replac |
| Re: Philips Magnavox 9P6444 64" RPTV has Green Haze | [quote:b1dfe1bdba="NTL1991"]Hello. I have a Philips Magnavox 64" Rear-Projection TV that was ma |
| I carefully looked at the picture you posted... | I must be blind... I see the CRT board. I don't see any white cabling that is loose. I may can be of |
| For one thing, there is no lasers in television sets. You have a cold solder connection for the heat |
| Sony PVM-2000PS Service info | Hi, I am looking for a circuit diagram (schematic) of the Sony PVM-2000PS Video Monitor.
It seems |
| TV BRIGHTNESS PROBLEM | HELLO, Picture brightness problems in projection tv's stem from many areas. If I were in your posit |
| Re: PHILIPS 32PW8506 , Bleu screen with flybacklines !? | Hi.herald ,ther is often problem with CRT ,blue cathode will by shorted.Do you check drive for RGB?? |
| check for loose conection on thecrt board and chroma section,and maybe there is an over load in the |
|
|
| [quote:f3c77eb6de="Electrodoc"]Absolutley Atom,
But I think knowing How much A User knows about el |
| Grundig TV Dead | Hi,
I have a Grundig 28wf100 CRT tv thats a few years old.
Last week it turned itself off and |
| Samsung Dynaflat 27 inch television | I just came back from classes today to find that my television was in terrible duress. It seems that |
| Sony trinitron | I have one CRT, sony trinitron model 330ab22. I search for an shem, so i can conekt this CRT, to ano |
| thomson 32sw23u icc17chassis with new transformerkit install | hi all have been following some posts on this model and have replaced a blown fbt with the kit from |
| Sony | The CRT is bad. If increasing the screen voltage does not solve the problem, you might as well star |
| VIEWSONIC DIM | HELLO, If this is a tv system with a flyback yes. Located on the flyback transformer is a pot call |
| L01 | Hi
I have had 2 l01s with this problem, sorry to say both sets the CRT was the cause one boosted c |
| I am not an expert but to my knowledge you probably won't get a shock from the flyback. The wire and |
| Re: rca 46 inch again.... | [quote:73d50fc6d4="jloy1"]so in my previous post i had a high voltage arc from the center crt to the |
| Sony | A model number would help to be more specific. The wire appears to be coming from the flyback trans |
| If HV stays on check CRT for weak emision. This will cause sony TV's to blank out the video. |
| I thought that might be it each Crt at the base on the flat board there are 2 pots on small one larg |